SESΒΆ
SES Displays all current disk enclosure faults.
This command will display a list of all current enclosure faults detected by the SCSI Enclosure Services (SES) as well as provide a means to access SES specific functions such as disk, channel, lun, or tier visual identification.
- DOWNLOAD
- Allows the operator to Download firmware to the enclosures. During downloading, SES will suspend enclosure monitoring.
- ENCLRESET=tc
- This parameter commands the system to send a RESET command to a specific enclosure, ‘tc’, where ‘t’ is the tier and ‘c’ is the channel of the enclosure. The valid range for ‘t’ is <1..128>. The valid range for ‘c’ is <ABCDEFGHPS>.
- EVENTLOG=tc
- This parameter commands the system to get and print to the console an Event Log from the specified enclosure, ‘tc’, where ‘t’ is the tier and ‘c’ is the channel of the enclosure. The valid range for ‘t’ is <1..128>. The valid range for ‘c’ is <ABCDEFGHPS>.
- ID=OFF
- This parameter clears the visual indication task that is currently in progress and restores the system to its original visual state.
- IDCHANNEL=c
- This parameter commands the system to provide a visual indication of the specified channel, ‘c’. The valid range for ‘c’ is <ABCDEFGHPS>.
- IDDISK=tc
- This parameter commands the system to provide a visual indication of the specified drive, ‘tc’, where ‘t’ is the tier and ‘c’ is the channel. The valid range for ‘t’ is <1..128>. The valid range for ‘c’ is <ABCDEFGHPS>.
- IDLUN=n
- This parameter commands the system to provide a visual indication of the specified LUN, ‘n’. The valid range for ‘n’ is <0..the max. number of LUNs> (which is set at 128 in the current system).
- IDTIER=t
- This parameter commands the system to provide a visual indication of the specified tier, ‘t’. The valid range for ‘t’ is <1..128>.
- MUTE=c
- This parameter commands the system to mute the enclosure alarms on the specified channel, ‘c’. The valid range for ‘c’ is <ABCDEFGHPS>.
- M_WAIT
- This parameter displays the current value for the SES device monitoring rate. The value is given in seconds.
- M_WAIT=x
This parameter sets the SES device monitoring rate for the system to ‘x’. The monitoring rate is given in seconds. The valid range for ‘x’ is <4..90>.
Warning
Improper use of this command can prevent the SES monitors from detecting an enclosure fault before the enclosure automatically shuts down.
- OFF
- Allows the user to save the SES state to the parameter blocks, and shutdown the SES monitors.
- ON
- Allows the user to save the SES state to the parameter blocks, and startup the SES monitors.
- SHOW=tc
- Allows the user to display the configuration information and the status information returned from an SES Enclosure Status page for the SES device for the specified drive, ‘tc’, where ‘t’ is the tier and ‘c’ is the channel. The valid range for ‘t’ is <1..128>. The valid range for ‘c’ is <ABCDEFGHPS>.
- SHOWALL
- Allows the user to display all configuration information for all the SES devices on all channels.
- SHOWDEVICES
- Allows the user to display all the SES devices on all channels.
- UNMUTE=c
- This parameter commands the system to unmute the enclosure alarms on the specified channel, ‘c’. The valid range for ‘c’ is <ABCDEFGHPS>.