APIΒΆ
API Display/Change the enabling/disabling of API connections.
Allows the user to display/change whether API connections are currently (temporarily) ENABLEd or DISABLEd. Note that this command only provides control over API connections during the current power cycle. To ‘permanently’ disable or enable API connections (i.e. across power-cycles), the user is referred to the NETWORK [[API_SERVER=ON|OFF] command. Note that the default setting for this command at power-on is ENABLEd.
- CLEARSTATS
- Resets the collected statistics on API connections.
- DISABLE
- Allows the user to (temporarily) disable the establishment of connections to the API Server. Users at remote locations will be unable to establish a new API connection until an API ENABLE command is issued.
- ENABLE
- Allows the user to (re-)enable the establishment of connections to the API Server.
- RESTART
- Allows the user to do a full restart on the API server.
- SHUTDOWN
- Allows the user to totally shutdown the API server. This command should not be used under normal circumstances, use API DISABLE to just turn off API accesses. Note: This command will only shutdown the API server during the current power cycle, refer to NETWORK API_SERVER in order to make command permanent.
- START
- Allows the user to start the API server the was shutdown using the API SHUTDOWN command. This command should not be used under normal circumstances. For most circumstances API ENABLE and API DISABLE are appropriate. Note: NETWORK API_SERVER must be set to ON for this command to work.
- STATS
- Displays the collected statistics on API connections.